Removing key rings

1 year 5 months ago #3571 by thcashregister@msn.com


  • Posts: 215

  • Gender: Unknown
  • Birthdate: Unknown
  • Removing key rings was created by thcashregister@msn.com
    Ok I need some help and advice. I am working on a 1064 model. I am trying to remove and save as many key rings as I can. I am having no luck. I have already ordered a new set from Bob(41 of them). Is there a good way to save any of them? I noticed that there is a crease in the front of each one. Is this to make them tighter from the factory?
    Well any help will be appreciated. Right now I am just using my drimmel to cut them off. I am saving the back plate.
    Rick

    Please Log in to join the conversation.

    1 year 5 months ago #3587 by dep


  • Posts: 247

  • Gender: Male
  • Birthdate: 19 Jul 1948
  • Replied by dep on topic Removing key rings
    They must be cut off. You cannot save any. They are crimped on the bottom edge at the factory. be caeful if trying to
    pry them off as you might tear off the entire cup off the key stem.
    dep

    Please Log in to join the conversation.

    Powered by Kunena Forum